A bombardment of stashbusting briars Part 1 of 3

I am sitting on the couch in a ray of sunshine and I can barely see my computer screen but I don’t care! Even though the temperatures are low, the sun offers a promise that spring is around the corner if I’m just a wee bit patient.

Briar0

Briar is definitely my favourite pattern at the moment. I only had time to make one in February for the sewalong, but now that I have a bit more time, I’ve been whipping them up like nobody’s business!

They probably take about 2 hours in total (a little more than two episodes of your favourite show) to make, including cutting out the fabric. There are only 4 pieces: a front, a back, and two sleeves, and because it’s made of jersey fabric, there’s no need for zippers. The only zipping you’re doing is zipping through this project!

I don’t have a serger, so I used a zigzag stitch for the seams and then trimmed them down to about 0.7cm (half of the seam allowance). And the hems were done with a twin needle. This is a must for sewing with jersey/knit fabric in my humble opinion!

The only other thing I’d say is to PRESS THOSE SEAMS AND HEMS. It’s recommended in the instruction booklet, and you should take it to heart.  I kept coming out with wavy hems, for example. I stretched them out a bit, then pressed them, and the tops look just like they came off a rack.

I’ve broken this post into 3 parts, one for each version of the briar. The other two are 3/4 sleeve and short sleeves.

GET READY FOR LOTS OF PHOTOS!

Version 1: long sleeves

For this version, I added 2 cm to the length of the top and I finished the neckline with a twin needle, just like with the hems.

briar2-1 velvet truffle

briar2-2

briar2-3

briar2-5

briar2-4

Click here for part 2

Click here for part 3

3 replies

Trackbacks & Pingbacks

  1. […] The retro-print, stash-busting Briar: This is probably my most-worn me-made make of 2013.  I absolutely love this top.  It is super […]

  2. […] ← A bombardment of stashbusting briars Part 1 of 3 […]

Leave a Reply

Want to join the discussion?
Feel free to contribute!

Leave a Reply